The Leak Controller/AquaGate is beeping, how do I shut it off?

A.  The Leak Controller has activated due to one of the following:

1.  water touching the sensor (leak or spill)
2.  low battery
3.  no testing for 2 years

Check for leaks and fix if necessary.  Dry sensor(s).  Open valve to reset

Now the Leak Controller/AquaGate is in normal open and ready position again.

step 2: Push and hold button down for 2 seconds (2 flashes) and push the right side manual close button (this closes the valve)  Release the button

step3:  Unit will confirm by beep and flash sequence (factory default is 1 flash, off)

beep/flash sequence:

1 =  off

2 =  6 month service reminder

3 =  12 month service reminder

4 =  18 month service reminder

step4:  Press the button and the unit will cycle to the number of beep/flash

note:  continuous pressing of the button will cycle to the beginning 1 flash and so on...

step5: After stopping on desired beep/flash number, manually open the valve to set (turn knob handle to green position

The service reminder is now set